0 $0.00
6" Carbide Hole Saw Cutter
Description
| Technical Details |
| 5 Stars | 3 reviews |
3 Most Useful Customer Reviews
Mike
Works well with an 18v DeWalt 3-speed drill that has enough torque for even 6 inch Mega hole cutters. I have drilled 2 1/2 inches through alabaster and ipe boards. This hole saw cuts a lot better than high speed steel hole cutters that I have used in the past.
George
I used this on inch thick plywood subflooring and was able to cut quickly using a DeWalt 18v cordless drill on its medium speed setting. Tried first hole on the lowest speed setting and it was OK but would jerk a little when it hit a harder section of the plywood. At the middle speed setting it was much smoother. Even on the low speed setting it was a whole lot smoother and easier to use than even the small sizes of the Lenox One Tooth hole cutters which are plain scary to use in a hand held drill.
Clean holes in seconds and the cut plug comes out in seconds. Long tooth life even in MDF, particle board, and plywood. I will never go back to using bi-metal hole saws for anything but metal.
Clean holes in seconds and the cut plug comes out in seconds. Long tooth life even in MDF, particle board, and plywood. I will never go back to using bi-metal hole saws for anything but metal.
Related Products
My Account
Reviews
- I used this on inch thick plywood subflooring and was able to cut quickly using a DeWalt 18v...George
- Read All Reviews...
Testimonials
I have to say that your 6-3/8" carbide Grit hole saw cutter is the best! Cuts through plaster...
Bruce
Hi, Just wanted to let you know that we are absolutely thrilled with the hole cutter. Wow, did...
Mike, Coastal Electric
I have had great success with the product. It works wonderfully... two contractors watched me...
Cliff - Electrician
The X-230 Works great. Hardi cement board can be a bear to cut, but this tool makes the job very...
E. Ebey, Contractor
The X-230+ with the 5/8" threaded arbor shaft allows me to use a 1" carbide grit hole saw and get...
Jim
