,

6 Inch Tungsten Carbide Tipped TCT Hole Saw Cutter

(3 customer reviews)

$35.00

Availability: In stock

SKU: HP1642 Categories: ,
Secure Checkout

Technical Details
• 6 inch MEGA tungsten carbide tipped  TCT with 2-1/4 inch cutting depth hole saw
• 3 TCT carbide teeth or more
• Cuts wood, sheetrock, fiber cement board, plaster, fiberglass, OSB, chipboard, MDF, and other tough materials
• Cut 40x more holes per charge with cordless drills
• Cut holes in 1/10 the time over bi-metal hole cutters
• Cut 6 inch holes in 1 inch thick plywood with 18v cordless drills
• Tough Tungsten Carbide teeth extend past inside and outside walls for reduced friction and much faster cutting
• Large side gullet slots for fast chip removal and fast plug removal
• Use any 5/8 inch-18 thread hole saw arbor and any standard 3-3/4 inch or longer pilot bit
• Do NOT use with 1/2 inch stud drills such as Milwaukee Hole Hawg which will cause the teeth to rip off
• USE on cordless drill MEDIUM to HIGH SETTING for best results

***Arbor and pilot bit NOT INCLUDED***

See carbide hole cutter in use with a Hole Pro Dust Shield https://holecutterstore.com/hole-pro-abs-dust-shields-arbor-adapters-and-vacuum-adapters.html

Weight .9 lbs
Dimensions 0.00 × 0.00 × 0.00 in

3 reviews for 6 Inch Tungsten Carbide Tipped TCT Hole Saw Cutter

  1. Carl

    This thing cuts about 5 times faster than bi-metal hole saws!

  2. Mike

    Works well with an 18v DeWalt 3-speed drill that has enough torque for even 6 inch Mega hole cutters. I have drilled 2 1/2 inches through alabaster and ipe boards. This hole saw cuts a lot better than high speed steel hole cutters that I have used in the past.

  3. George

    I used this on inch thick plywood subflooring and was able to cut quickly using a DeWalt 18v cordless drill on its medium speed setting. Tried first hole on the lowest speed setting and it was OK but would jerk a little when it hit a harder section of the plywood. At the middle speed setting it was much smoother. Even on the low speed setting it was a whole lot smoother and easier to use than even the small sizes of the Lenox One Tooth hole cutters which are plain scary to use in a hand held drill.

    Clean holes in seconds and the cut plug comes out in seconds. Long tooth life even in MDF, particle board, and plywood. I will never go back to using bi-metal hole saws for anything but metal.

Add a review

Your email address will not be published. Required fields are marked *

Shopping Cart
Shopping cart0
There are no products in the cart!
Continue shopping
0
Scroll to Top